Page 3 of Induction Kit
13. Connect throttle return spring and adjust throttle, making sure you get full throttle when accelerator pedal is depressed. Connect choke wire as follows: pull choke knob out about 3 inches, connect choke outer to locating bracket on carburetor and secure, Now cut outer and inner flush with retainer, then push choke knob fully in and connect inner cable with choke lever and secure.
14. Remove air cleaner locating stud from old carburetor and insert in four barrel. Position new air cleaner and secure. Connect breather hose from oil filter cap to elbow at base of air cleaner and secure. (NOTE:- Use hexagon nut only, do not use Dome nut, as due to its extra height it may foul hood.)
15. Connect yellow and black brake servo hose to banjo at forward end of manifold and secure.
16. Refill cooling system, start engine and adjust idle, road test and when engine has reached normal running temperature, re-check idle.
17. Secure brake servo pipe to re-inforcement bar fire wall to wheel arch with Nylon TY-RAP supplied.
18. Secure heater hose return pipe to fuel line with Nylon TY-RAP supplied to avoid chafing against fuel filter.
**
| 